LSIS LSLV0055H100-4COFN - Page 137

123
Learning Basic Features
The 100% output voltage in the figure below is based on the parameter settings of BAS-15
(motor rated voltage). If BAS-15 is set to ‗0‘ it will be based on the input voltage.
• When a normal induction motor is in use, care must be taken not to configure the output
pattern away from a linear V/F pattern. Non-linear V/F patterns may cause insufficient motor
torque or motor overheating due to over-excitation.
• When a user V/F pattern is in use, forward torque boost (DRV-16) and reverse torque boost
(DRV-17) do not operate.