LSIS LSLV0055H100-4COFN - Page 168

Learning Advanced Features
154
Group
Code
Name
LCD Display
Parameter Setting
Setting
Range
Unit
ADV
70
Safe operation
selection
Run En Mode
1
DI Dependent
0-1
-
71
Safe operation
stop mode
Run Dis Stop
0
Free-Run
0–2
-
72
Safe operation
deceleration
time
Q-Stop Time
5.0
0.0–600.0
sec
IN
65–
71
Px terminal
configuration
Px Define(Px:
P1–P7)
15
RUN Enable
0-55
-
Safe Operation Mode Setting Details
Code
Description
IN-65–71 Px
Define
From the multi-function terminals, select a terminal to operate in safe
operation mode and set it to ‗15 (RUN Enable)‘.
ADV-70 Run En
Mode
Setting
Function
0
Always Enable
Enables safe operation mode
1
DI Dependent
Recognizes the operation command from a
multi-function input terminal.
ADV-71 Run Dis
Stop
Set the operation of the inverter when the multi-function input terminal in
safe operation mode is off.
When the safety operation mode terminal signal is given, the inverter
decelerates based on the settings at the Q-Stop time. The inverter
decelerates and stops based on the deceleration time (Dec Time) settings
if the run command is off.
Setting
Function
1
Free-Run
Blocks the inverter output when the multi-
function terminal is off.
2
Q-Stop
The deceleration time (Q-Stop Time) used in
safe operation mode. It stops after deceleration
and then the operation can resume only when
the operation command is entered again. The
operation will not begin if only the multi-function
terminal is on.
3
Q-Stop
Resume
The inverter decelerates to the deceleration time
(Q-Stop Time) in safe operation mode. It stops
after deceleration. Then if the multi-function
terminal is on, the operation resumes as soon
as the operation command is entered again.