LSIS LSLV0055H100-4COFN - Page 258

Learning Advanced Features
244
Grou
p
Code
Name
LCD Display
Parameter Setting
Setting
Range
Unit
IN
65–
71
Px terminal
configuration
Px Define(Px: P1–
P7)
28
2nd Motor
0-55
-
2
nd
Motor Operation Setting Details
Code
Description
IN-65–71 Px
Define
Set one of the multi-function input terminals (P1–P5) to 26 (2nd Motor) to
display the M2 (2nd motor group) group. An input signal to a multi-function
terminal set to 2nd motor will operate the motor according to the code
settings listed below. However, if the inverter is in operation, input signals to
the multi-function terminals will not read as a 2nd motor parameter.
PRT-50 (Stall Prevent) must be set first, before M2-28 (M2-Stall Lev)
settings can be used. Also, PRT-40 (ETH Trip Sel) must be set first, before
M2-29 (M2-ETH 1 min) and M2-30 (M2-ETH Cont) settings.
Parameter Setting at Multi-function Terminal Input on a 2nd Motor
Code
Description
Code
Description
M2-04 Acc Time
Acceleration time
M2-15 M2-
Efficiency
Motor efficiency
M2-05 M2-Dec
Time
Deceleration time
M2-17 M2-Rs
Stator resistance
M2-06 M2-
Capacity
Motor capacity
M2-18 M2-Lsigma
Leakage inductance
M2-07 M2-Base
Freq
Motor base frequency
M2-25 M2-V/F Patt
V/F pattern
M2-08 M2-Ctrl
Mode
Control mode
M2-26 M2-Fwd
Boost
Forward torque boost
M2-10 M2-Pole
Num
Pole number
M2-27 M2-Rev
Boost
Reverse torque boost
M2-11 M2-Rate
Slip
Rated slip
M2-28 M2-Stall Lev
Stall prevention level
M2-12 M2-Rated
Curr
Rated current
M2-29 M2-ETH 1
min
Motor heat protection 1
min rating
M2-13 M2-Noload
Curr
No-load current
M2-30 M2-ETH
Cont
Motor heat protection
continuous rating
M2-14 M2-Rated
Motor rated voltage