LSIS LSLV0055H100-4COFN - Page 269

255
Learning Advanced Features
Code
Description
󰪾 Existing parameter registered as the user group code 40
󰪿 Setting range of the user group code. Entering ‗0‘ cancels
the settings.
3
󰪽 Set a code number to use to register the parameter in the
user group. Select the code number and press the
[PROG/ENT] key.
4
Changing the value in 󰪽 will also change the value in 󰪾. If
no code is registered, ‗Empty Code‘ will be displayed.
Entering ‗0‘ cancels the settings.
5
The registered parameters are listed in the user group in
U&M mode. You can register one parameter multiple times if
necessary. For example, a parameter can be registered as
code 2, code 11, and more in the user group.
Follow the procedures below to delete parameters in the user group.
No.
Settings
1
Set CNF- 42 to ‗3 (UserGrp SelKey)‘. A icon will be
displayed at the top of the LCD display.
2
In the USR group in U&M mode, move the cursor to the code
that is to be deleted.
3
Press the [MULTI] key.
4
Move to ‗YES‘ on the deletion confirmation screen, and press
the [PROG/ENT] key.
5
Deletion completed.
CNF-25 UserGrp
AllDel
Set to ‗1 (Yes)‘ to delete all registered parameters in the user group.