LSIS LSLV0055H100-4COFN - Page 366

RS-485 Communication Features
352
Code
Description
Setting
Communication Speed
0
1200 bps
1
2400 bps
2
4800 bps
3
9600 bps
4
19200 bps
5
38400 bps
6
56 Kbps (57,600 bps)
7
76.8 Kbps (76,800 bps)
8
115 Kbps (115,200 bps)
If the COM-02 Int485 Prtoto setting is BACnet, the available
communication speed settings are 9600 bps, 19200 bps, 76.8 kbps.
If the COM-02 Int485 Prtoto setting is Metasys-N2, the communication
speed is fixed to 9600 bps and COM-03 Int485 BaudR is not shown.
COM-04 Int485
Mode
Set a communication configuration. Set the data length, parity check
method, and the number of stop bits.
Setting
Function
0
D8/PN/S1
8-bit data / no parity check / 1 stop bit
1
D8/PN/S2
8-bit data / no parity check / 2 stop bits
2
D8/PE/S1
8-bit data / even parity / 1 stop bit
3
D8/PO/S1
8-bit data / odd parity / 1 stop bit
If the COM-02 Int485 Prtoto setting is Metasys-N2, the communication
frame composition is fixed to D8/PN/S1 and COM-04 Int485 Mode is not
visible.
COM-05 Resp
Delay
Set the response time for the slave (inverter) to react to the request from the
master. Response time is used in a system where the slave device
response is too fast for the master device to process. Set this code to an
appropriate value for smooth master-slave communication.