Step 4 Control Terminal Wiring
The illustrations below show the detailed layout of control wiring terminals and control board
switches. Refer to the detailed information provided below and 1.5 Cable Selection on page
10 before installing control terminal wiring and ensure that the cables used meet the
required specifications.
Switch Symbols and Description
Terminating Resistor selection switch (Left: On, Right: Off)
NPN/PNP mode selection switch (Left: PNP, Right: NPN)
V1/T1 (PTC) mode selection switch (Left: V1, Right: T1)
analog voltage/current input terminal selection switch (Left: I2, Right:
V2)
analog voltage/current output terminal selection switch
(Left: VO, Right: IO)
To Next Page
Loading...
