LSIS LSLV0055H100-4COFN - Page 54

Installing the Inverter
40
Disabling the Built-in EMC Filter for 0.75–30 kW (3–Phase) Inverters
Refer to the figures below to locate the EMC filter on/off terminal and replace the metal bolt
with the plastic bolt. If the EMC filter is required in the future, reverse the steps and replace
the plastic bolt with the metal bolt to reconnect the EMC filter.
If the EMC filter is required in the future, reverse the steps and replace the plastic bolt with
the metal bolt to enable the EMC filter.