LSIS LSLV0055H100-4COFN - Page 602

588
Ｇ
ground .................................................................................................. 26
class 3 ground ..................................................... 27
ground cable specifications ................................ 10
ground fault trip ............................... Refer to Ground Trip
Ground Trip .................................................................................... 554
Ｈ
H100 expansion common area parameter ........... 403
control area parameter (Read/Write) .............. 414
memory control area parameter (Read/Write)
....................................................................... 418
monitor area parameter (read only) ................ 403
half duplex system ................................................................... 373
Ｉ
I/O point map.............................................................................. 434
I2 38
analog input selection switch (SW4) ................. 38
frequency setting(current/voltage) terminal ...... 38
I2 Terminal ...................................................................................... 101
IA (illegal data address) ........................................................ 392
ID (illegal data value) ............................................................. 393
IF (illegal function) .................................................................... 392
IN (Input terminal function group) .................... 62, 460
In Phase Open ............................................................................. 554
initializing accumulated electric energy count ... 287
input and output specifications ..................................... 577
input open-phase fault trip .............. Refer to In Phase
Open
input phase open
input open-phase protection ............................ 350
input power frequency ......................................................... 277
input power voltage ............................................................... 278
input power voltage settings ........................................... 277
input terminal ..................................................................... 37, 156
A (NO) or B (NC) terminal configuration ......... 156
bit setting ............................................................ 156
CM terminal ..........................................................37
I2 terminal .............................................................38
NO/NC configuration ........................................ 156
P1–P7 terminal ....................................................37
TI terminal ............................................................38
V1 terminal ...........................................................37
VR terminal ..........................................................37
input terminal contact
A contact ............................................................ 351
B contact............................................................ 351
Input terminal function group ...... Refer to IN (Input
terminal function group)
inspection
annual inspection .............................................. 569
bi-annual inspection ......................................... 572
daily inspection ................................................. 568
installation .......................................................................................... 14
basic configuration diagram ...........................16
installation flowchart ............................................14
location ................................................................... 6
mounting the Inverter ..........................................17
side-by-side installation ......................................... 8
wiring .....................................................................24
installation conditions .................................................................. 5
INV Over Load
Inv Over Load Warning .................................... 557
Inverter OLT ................................................................................... 554
inverter overload protection (IOLT) ............................. 352
Inverter overload warning .................................................. 371
IO Board connection fault trip ...... Refer to IO Board
Trip
IO Board Trip ................................................................................ 557
IP 20 .................................................................................................... 582
IP 20 Type external dimensions ..................................... 584
Ｊ
Jog operation ............................................................................... 167
FWD Jog ........................................................... 167
Jog frequency ................................................... 167
Jog operation 2 by terminal input .................... 168
Jog operation 2-Rev Jog by terminal input ......... 168
jump frequency .......................................................................... 152