LSIS LSLV0055H100-4COFN - Page 609

595
목차
Ｔ
target frequency
Cmd frequency .................................................. 439
Temperature sensor fault trip ......................... NTC Open
terminal
A terminal .................................................. 156, 331
B terminal .................................................. 156, 331
terminal for frequency reference setting ...... Refer to
VR terminal
terminal screw specifications ........................................... 588
Terminating Resistor selection switch (SW1) .......... 34
test run ................................................................................................. 50
Thermal Trip .................................................................................. 556
TI terminal .............................................................................. 38, 104
Time Event ...................................................................................... 242
time event scheduling ........................................................... 242
Exception Date .................................................. 242
module types ..................................................... 242
parameters ........................................................ 242
RTC battery ....................................................... 242
RTC clock .......................................................... 242
Time Event......................................................... 242
Time Period Module ......................................... 242
Time Period Module ............................................................... 242
time scale setting ...................................................................... 121
0.01sec .............................................................. 121
0.1sec ................................................................. 121
1sec .................................................................... 121
timer ................................................................................................... 290
protection features groupPRT (protection features)
group
TO terminal .................................................................................... 319
torque.................................................................................................... 24
torque boost ................................................................................. 137
auto torque boost .............................................. 138
manual torque boost ......................................... 137
overexcitation .................................................... 138
trip ........................................................................................................ 553
erasing trip history ............................................. 287
fault/waring list ................................................... 370
trip no motor trip ................................................ 366
trip status reset.................................................. 365
troubleshooting ................................................. 558
Trip mode ........................................................................................... 61
Trip mode ........................................................................................ 531
troubleshooting .......................................................................... 553
fault trips ............................................................ 558
other faults ......................................................... 561
Ｕ
U&M mode ....................................................................... 284, 385
U/V/W terminals ............................................. 29, 31, 32, 562
Under Load
Under Load Trip ........................................ 359, 554
Under Load Warning ................................ 359, 557
underload fault trip ............................................ 370
underload warning ............................................ 371
underload fault trip ........................ Refer to Under Load
Unipolar ............................................................................................... 37
up-down operation ................................................................. 169
User & Macro mode ............................................... 60, 61, 64
User group ..................................................................................... 284
delete parameters ............................................ 284
parameter registration ...................................... 284
User mode......................................................................................... 64
user V/F pattern operation ................................................ 135
User/Macro group
parameter group ............................................... 385
U&M mode ........................................................ 385
using the keypad.......................................................................... 64
Ｖ
V/F control...................................................................................... 132
linear V/F pattern operation ............................. 132
square reductionV/F pattern operation ........... 133
user V/F pattern operation ............................... 135
V/F pattern configuration ....................................83
V1 terminal............................................................................... 37, 93
V1/T1 (PTC) mode selection switch (SW3) ............... 34
V2
analog input selection switch (SW4) .................38