LSIS LSLV0055H100-4COFN - Page 63

Learning to Perform Basic Operations
49
Key
Name
Description
[MODE] Key
Used to switch between modes.
[PROG / Ent]
Key
Used to select, confirm, or save a parameter value.
[Up] key
[Down] key
Switch between codes or increase or decrease parameter
values.
[Left] key
[Right] key
Switch between groups or move the cursor during parameter
setup or modification.
[MULTI] Key
Used to perform special functions, such as user code
registration.
[ESC] Key
Used to cancel an input during parameter setup.
Pressing the [ESC] key before pressing the [PROG / ENT]
key reverts the parameter value to the previously set value.
Pressing the [ESC] key while editing the codes in any function
group makes the keypad display the first code of the function
group.
Pressing the [ESC] key while moving through the modes
makes the keypad display Monitor mode.
[HAND] Key
Used to switch to HAND (local/manual) operation mode.
[OFF] Key
Used to switch to OFF (standby) mode or to reset the inverter
faults.
[AUTO] Key
Used to switch to AUTO (remote) operation mode.