To Next Page

To Previous Page

dot2 User Manual

Renumber the cue list

You can renumber a single cue or a range of cues. Press and hold a cue number in the Cues view. This opens the

Edit Cue Number(s) window. It could look like this:

At the top of this window you can set the range of cue you want to renumber. Then you set the new beginning

number and the step width for the cues. When you are happy with your settings, then you tap the Renumber

button.

You can't use renumber to move a cue - and the cue list always have the in numeric order. So you can only

renumber the cue(s) inside the boundaries of any cues before and or after the set range.

Deleting a Cue

You can delete a cue by using the Delete key. When you delete a cue, you might be asked if you want to delete

the cue the "Normal" way or using "Cue Only". You are only asked if you delete a cue that isn't the last cue.

"Normal" will result in values tracking from the previous cue into the next. Values that might been changed in the

cue you are deleting. "Cue Only" will leave the following cues looking the way they did before you delete the cue.

MA dot2 User Manual

Other manuals for MA dot2