The front
The front of a dot2 core looks like this:
Throughout this guide I'll mention different areas of the console.
This is a short walk-through of the different ares:
1. Command section - This is where you have access to most of the functions on the console using keys.
2. Encoders - The encoders are used to select and change values and options. You can press an encoder to
confirm your current choice and sometimes open other windows. The functions of the encoders changes
throughout the different sections of the console. The current function and values can be viewed on the
screen above them (indicated with number 10 - Screen 1).
3. Main Executor - This is the main executor section. Here you'll most likely put your primary cue list.
4. Executors with faders - These executors can also have cue lists, but they could also have chasers, group
masters and other functions. There's one key under the fader with this symbol . This is the executor GO
key. The one below this have this symbol , this is the executor Flash key. The executors are numbered
from the Main executor (number three) to the left. So the one closest to the Main executor is executor
number 1.
To Next Page
Loading...
Need help?
General