In the previous chapter you might have noticed that when we changed the values of the fixture there was a red line
on the Dimmer button on the right side of screen 1. It looked like this:
And when we pressed Clear , it went away.
This indicated to us that we had dimmer values in the programmer.
If you want to see more detailed what you actually have in your programmer you need to do a little modification to
the Fixtures view.
We have been looking at the fixture view in symbol style until now. We are going to change this into the sheet style.
In the upper right corner of the Fixture view there are three buttons. You need to press the one in the middle.
To Next Page
Loading...