The position preset type view is fragmented in the position view and the raw position view.
To open the position effects view at screen 1, tap at in the title bar.
If an effect is running on a selected fixture, the position preset type view change into an effect mode and get a blue
effect mode title bar.
Position View
The position view is the first tab of the position preset type view.
In the position view, you control the actual position values in degrees.
Pan Slider: To select the pan value, move the slider up or down.
Tilt Slider: To select the tilt value, move the slider up or down.
To bring the fixture type into the center position, tap Center .
Rightmost of the view are several buttons to adjust the position values.
There are two functions to adjust pan and tilt together.
Flip: To change the pan and tilt combination and point your fixture in the same direction, tap Flip .
To Next Page
Loading...
Need help?
General