MA dot2 - Page 400

© 2015 MA Lighting Technology GmbH - Dachdeckerstr. 16 - D-97297 Waldbüttelbrunn - Germany - www.malighting.com
dot2 User Manual
Description
With the select command, you select fixtures
by DMX address
from a cue list stored on a executor
from a specific cue
The selected fixtures are displayed in the fixtures view.
Syntax
1. Select fixtures in the fixtures view by DMX address.
Select Dmx 1.1
2. Select all fixtures from a cue list stored on a executor.
Select ExecButton1 1.1
3. Select all fixtures in a specific cue.
Select Cue 1 ExecButton1 1.2
Example 1
Let´s assume, you will select the fixture using the DMX address 1.1.
Press Select and tap in the DMX view at 1.1 .
The fixture with the DMX address 1.1 is selected.
Example 2
Let´s assume, you will select all fixtures from the cue list, stored on executor 1.
There are three ways to do this:
a) Press Select and then press the respective executor button e.g. .
b) Press Select and then tap on executor 1 in the executor bar view.
c) Press Select Exec 1 Please .
All fixtures stored on executor 1 are selected in the fixtures view.
Example 3
Let´s assume, you will select all fixtures from cue 1 on executor 1.
There are three ways to do this:
400