This page describes the syntax and how to use the zero command.
If you type the Zero command in the console, by double press the . key, the command will be directly
executed.
You can also use the command line along with the virtual keyboard and type the word zero in.
To go to the zero command double press the . key on the console.
The command will be directly executed.
Description
With the zero command you can set the intensity to zero
of the current selected fixtures
of a selection of fixtures
from an executor
Syntax
1. Set the intensity from the current selected fixtures to zero.
Zero
2. Set the intensity of a selection of fixtures to zero.
Fixture 1 Thru 3 Zero
3. Set the intensity from an executor to zero.
Executor 1 Zero
Example 1
Let´s assume you will set the intensity of all selected fixtures to zero.
Press . . .
The zero command will be directly executed.
The values of the selected fixtures are zero.
Double check the executed command in the command history.
Example 2
To Next Page
Loading...
Need help?
General