Let's add some moving lights to our patch. We are going to add 6 pieces of GLP Impression X4 in "Compressed"
mode and 9 Clay Paky Alpha Profile 700 in "Standard Lamp on" mode.
This is our new plot:
Let's add the fixtures together.
Again we need to go to Setup and the Patch & Fixture Schedule .
We need to add new fixtures.
In the type field there's a symbol you need to learn. It's three white vertical dots. It looks like this:
When you press this, then you get a drop down list.
If you do this in the type field then we get a list of the fixture types that already exists in our show. When we added
the ETC Vivids, we took a copy from the fixture library and copied it into our show.
We need to do the same with the GLP X4's. Press Select others... and find the GLPs (impression X4 -
"Compressed" mode). When you have found them you need to press the OK in the upper right corner.
The quantity should be six.
We need to give them a Fixture ID. Press Select... next to the ID field. This opens the Select Fixture ID pop-up.
Here you can see the occupied fixture IDs and the name of the fixtures who has them. Select 31 and press OK in
the upper right corner.
To Next Page
Loading...