We haven't bothered with the name so far and we are not really going to begin now. But I will tell you one thing
about naming. When you write something for a name and the make a space and then a number, then the rest of
the fixtures will be enumerated from that number.
Let's give them a patch. Press the three dotted drop down list symbol in the patch input field. This give you a
different option for selecting a universe and an address. If you know the start address you can also just type this using
the numeric keys.
We need to patch the GLPs at universe 3 address 1 - this is typed 3.1.
Now we can press the OK button in the upper right corner.
That was the GLPs. We still need to add the Clay Pakys.
The process is the same, so I'll just give you the information you need:
Clay Paky - Alpha Profile 700 - Standard Lamp on
9 fixtures
Beginning fixture ID is 41
The patch address is 4.1
When you added them, then we can leave the Fixture Setup view by pressing the Done in the upper right corner
and Apply the Changes .
Notice the extra fixtures in the fixture view and how they are organized by fixture type.
In the next chapter we are going to look at controlling all the extra features we just got.
To Next Page
Loading...
Need help?
General