214683 xv Revision A
Setting the Sensitivity of the Auto Header Height Control (CLAAS 600 and 700 Series)................255
Adjusting Auto Reel Speed (CLAAS 600 and 700 Series) ..........................................................256
Calibrating Reel Height Sensor (CLAAS 600 and 700 Series) ....................................................258
Adjusting Auto Reel Height (CLAAS 600 and 700 Series) ..........................................................260
3.8.15 New Holland Combines (CR/CX Series—Pre-2015 Model Year) ...............................................261
Checking Voltage Range from the Combine Cab (New Holland).................................................261
Setting up Auto Header Height Control (New Holland CR/CX Series) .........................................264
Calibrating the Auto Header Height Control (New Holland CR/CX Series) ...................................265
Adjusting Header Raise Rate (New Holland CR/CX Series) .......................................................268
Setting the Header Lower Rate (New Holland CR/CX Series).....................................................268
Setting the Sensitivity of the Auto Header Height Control (New Holland CR/CX Series)................269
Setting Preset Cutting Height (New Holland CR/CX Series) .......................................................270
3.8.16 New Holland Combines (CR Series— Model Year 2015 and Later) ............................................271
Checking Voltage Range from the Combine Cab (New Holland CR Series) .................................271
Setting up Auto Header Height Control (New Holland CR Series) ...............................................274
Calibrating the Auto Header Height Control (New Holland CR Series).. .......................................277
Checking Reel Height Sensor Voltages (New Holland) ..............................................................280
Setting Preset Cutting Height (New Holland CR Series – 2015 and Later) ...................................281
Setting Maximum Work Height (New Holland CR Series)... ........................................................283
Configuring Reel Fore-Aft, Header Tilt, and Header Type (New Holland CR Series).....................284
3.9 Leveling the Header .........................................................................................................................286
3.10 Unplugging the Cutterbar................................................................................................................288
3.11 Unplugging the Float Module...........................................................................................................289
3.12 Transporting the Header ................................................................................................................290
3.12.1 Transporting Header on Combine ...........................................................................................290
3.12.2 Towing.................................................................................................................................. 290
Attaching Header to Towing Vehicle .........................................................................................291
Towing the Header..................................................................................................................291
3.12.3 Converting from Transport to Field Position ... ..........................................................................292
Removing Tow-Bar .................................................................................................................292
Storing the Tow-Bar ................................................................................................................293
Moving Front (Left) Wheels into Field Position ..........................................................................295
Moving Rear (Right) Wheels into Field Position.........................................................................296
3.12.4 Converting from Field to Transport Position ... ..........................................................................298
Moving Front (Left) Wheels into Transport Position ...................................................................298
Moving Rear (Right) Wheels into Transport Position..................................................................300
Attaching Tow-Bar ..................................................................................................................303
3.13 Storing the Header .........................................................................................................................306
Chapter 4: Header Attachment/Detachment................................................................................307
4.1 Float Module Feed Auger Configurations ...........................................................................................307
4.1.1 Converting from Ultra Narrow Configuration or Narrow Configuration to Medium
Configuration....................................................................................................................310
4.1.2 Converting from Wide Configuration to Medium Configuration ....................................................313
4.1.3 Converting from Medium Configuration or Wide Configuration to Narrow Configuration ................315
4.1.4 Converting from Ultra Narrow Configuration to Narrow Configuration . .........................................317
4.1.5 Converting from Medium Configuration to Wide Configuration ....................................................318
4.1.6 Converting from Ultra Narrow or Narrow Configuration to Wide Configuration ..............................320
TABLE OF CONTENTS
To Next Page
Loading...
