214683 381 Revision A
Figure 4.162: Float Module Latch
20. Remove screw (A) and remove nut and bolt (B) from
both sides of the opening to allow the attachment of the
float module deck.
21. Rotate the latch (C) forward and down to engage the
transition pan tube.
Figure 4.163: Float Module Latch
22. Use a 24 mm (15/16 in.) wrench on hex bolt (C) to
rotate latch downwards and slightly raise the feed deck.
Install nut and bolt (B) to lock the latch position.
23. Install screw (A).
24. Repeat for the opposite side of the feed draper deck.
Figure 4.164: Fillers
25. Install fillers (B) on the transition pan support angle (C)
using two bolts (A).
HEADER ATTACHMENT/DETACHMENT
To Next Page
Loading...
