Medoc PATHWAY - Analysis Report Types; Table 22: Report Advanced Options; Table 23: Built-In Report Templates

Pathway Technical Reference Manual
Proprietary 100 of 190
8. Advanced Options: the advanced options enable you to configure the results which will be
displayed in the report. The following options are available:
Table 22: Report Advanced Options
Parameter
Description
Number of Trials
Specify number of trials to display (relevant only for trial based
programs such as Limits or Levels)
Start Time
Specify start time of graph (relevant only for time based
programs such as Ramp and Hold or Pulses)
End Time
Specify end time of graph
Min. Value.
Specify minimum temperature to display on graph
Max. Value.
Specify maximum temperature to display on graph
9.3.1 Analysis Report Types
There are a number of different report templates which can be used to generate a report from
the selected test results. The available report template depends on specific parameters of the
selected report.
Report templates can be edited and customized according to specific
needs. For further information refer to section 10.1.2.
The following templates are available:
Table 23: Built-in Report Templates
Report
Type
Description
Restrictions
Singles
Simple report which displays the
selected test results. One report
will be generated for each test
results.
None
Multiple /
Multiple
grouped by
Patient
A Statistic summary of results
from more than one test.
Test Methods: TSL, Levels, Limits
Selection of 2 or more result files
Bilateral
Compares test statistics for both
sides (left and right) of the same
body site for the same patient.
Test Methods: TSL, Levels, Limits
Selection of 2 result files
Identical Test Subject
Identical Test Program
Identical Main and Specific body site
Opposite body site sides