Pathway Technical Reference Manual
Proprietary 43 of 190
4. Setup and Installation
The PATHWAY system installation is designed to be simple and fast. Follow the instructions
given below for selecting a location, installing and initial setup of the PATHWAY system.
Proper installation and operation of the equipment is important for ensuring the safety of the
tested subjects.
Before connecting the PATHWAY system to a power outlet, make
sure it has been in an upright position for a minimum of 3 hours!
Disregarding the above instruction will cause damage to the
PATHWAY system and Cooling Unit!
Complete and verify the entire PATHWAY setup and installation process
before using the system
For fMRI mode system installation see section 1415, page 149...
4.1 Computer Requirements
The requirements below are minimum requirements intended to be used as a guideline for
selecting a computer to use with Medoc Main Station software.
Computer must comply with IEC 950 – EN 60950 – UL 60950
Intel Core i3 4xxx or better
(avoid low power processors such as Atom, Pentium or Celeron)
2 free USB slots (3 for AlgoMed and Q-Sense CPM)
1366 x 768 pixels, 96 DPI (max. 1920x1080)
Windows 7, 8, 10 32/64 bit
Microsoft Office 2007 or above (required for viewing results in excel)
The computer used for Medoc Main Station software should be dedicated
for this purpose only. Medoc takes no responsibility for any conflicts which
may occur with other programs
For optimal performance disable any other resource heavy programs
running on the same computer such as Anti-Virus, Screen Saver, Hibernate
Mode, and Network connections.
To Next Page
Loading...