Medoc PATHWAY - Figure 21: Self-Test Prompt; Figure 22: PATHWAY in Rest Mode

Pathway Technical Reference Manual
Proprietary 52 of 190
8. When communication is established, the system will enter SAFE MODE and remain in this
state until completing the system Self-Test, see section 5.1 above. Make sure the
Thermode is not attached to the Subject and click on OK on the following message:
Figure 21: Self-Test Prompt
9. The system will perform a complete Self-Test of all enabled Thermodes according to your
system settings.
10. After the system Self-Test has completed successfully, the system state will change to
REST MODE.
Figure 22: PATHWAY in Rest Mode