Pathway Technical Reference Manual
Proprietary 47 of 190
3. Double-click Setup.exe to start software installation
4. Click Next to continue the installation.
5. Select the file location where Medoc Main Station should be installed. You can use the
location recommended by the installation. Click Next to continue.
6. Select the location of the Medoc Main Station shortcuts in the start menu. You can use the
location recommended by the installation. Click Next to continue.
7. Installing normative data – please read the agreement carefully. If you agree to the term
please choose to install normative data. Click Next to continue.
8. Privacy – please read the terms carefully. If you agree please choose to allow data
collection. You may cancel this option any time later if you choose to.
9. The installation is now in progress. Depending on your computer configuration it may take
up to several minutes.
10. After installation has completed, click Finish to close the wizard.
11. Restart your Computer.
12. Medoc Main Station software is now ready to be used.
4.8 Unit Protection
Keep all liquids away from the PATHWAY system.
Unplug the power supply of the PATHWAY system from electricity if it is
not to be used for a long period of time.
Do not block airflow anywhere around the PATHWAY system and
Thermode.
When all setup and installation procedures have been completed you can
start using the system in accordance with the operation instructions in
section 5.
To Next Page
Loading...