Medoc PATHWAY - Technical Data; PATHWAY - ATS Model Only; PATHWAY - CHEPS Model Only; Table 2: PATHWAY ATS Specifications

Pathway Technical Reference Manual
Proprietary 25 of 190
1.8 Technical Data
Medoc reserves the right to change specifications without prior notice, in
line with the company policy of constant product improvement
Some of the specifications require specific license / hardware which are
not available in the standard configuration.
The table below describes the technical specifications and capabilities of the Pathway system.
When stated, the term 'Optional' indicates that this specific feature requires an additional
license and/or hardware component.
1.8.1 PATHWAY – ATS model only
Table 2: PATHWAY ATS Specifications
Parameter
Description
ATS Thermode (probe)
active area
30 mm × 30 mm (standard)
16 mm × 16 mm (small)
Thermode temperature
range
0 – 55°C (Optional -10 °C to 55 °C)
Baseline thermode
temperature
10 – 45°C, programmable
Rate of temperature change
- Linear mode
0.1 – 8 °C/sec (Range may be lower depending on protocol
used). Note: Rate may vary within ±10%
1.8.2 PATHWAY – CHEPS model only
Table 3: PATHWAY CHEPS Specifications
Parameter
Description
CHEPS Thermode (probe)
active area
27 mm diameter
Thermode temperature
range
30 – 55°C (Optional 20 – 55°C)
Baseline thermode
temperature
30 – 45°C, programmable
Temperature change rate
Increase rate 0.1 – 70°C/sec
Decrease rate 0.1 – 40°C/sec
Range may vary depending on protocol used. Note: Rate
may vary within ±10%