Mold-Masters Hot Runner

To Next Page

To Previous Page

Table 1-1 Release Details

Document Number Release Date Version

HR--UM--EN--00--31-1 April 2021 31-1

HR--UM--EN--00--31-2 May 2021 31-2

HR--UM--EN--00--31-3 June 2021 31-3

1.4 Warranty

For current warranty information please refer to the documents available from

our website: www.moldmasters.com/support/warranty or contact your Mold-

Masters representative.

1.5 Returned Goods Policy

Please do not return any parts to Mold-Masters without pre-authorization and

a return authorization number supplied by Mold-Masters.

Our policy is one of continuous improvement and we reserve the right to alter

product specications at any time without giving notice.

1.6 Movement or Resale of Mold-Masters

Products or Systems

This documentation is intended for use in the country of destination for which

the product or system was purchased.

Mold-Masters takes no responsibility for documentation of products or

systems if they are relocated or resold outside the intended country of

destination, as stated on the accompanying invoice and/or waybill.

1.7 Copyright

and the Mold-Masters logo are trademarks of Mold-Masters.

1-2

INTRODUCTION

Hot Runner User Manual

Mold-Masters Hot Runner - 1.4 Warranty