Mold-Masters Hot Runner - Melt-CUBE Design A: Dual Nozzle Assembly; Melt-CUBE Design A: Inspection; Melt-CUBE Design A: Cleaning

19.3.3 Melt-CUBE Design A: Dual Nozzle Assembly
1
4
2
3
1. Melt-Link (top)
2. Melt-Link (bottom)
3. Melt-CUBE center locator
4. Dual gate Melt-CUBE
19.3.4 Melt-CUBE Design A: Inspection
Inspect critical dimensions for cavity cutout.
IMPORTANT
These dimensions must match the General Assembly drawing.
19.3.5 Melt-CUBE Design A: Cleaning
CAUTION
Ensure that the critical surfaces are not damaged during the cleaning
process.
CAUTION
1. Wipe down the Melt-CUBE.
2. If necessary, use a cotton swab to clean narrow interior surfaces or screw
threads. Spray lacquer thinner on larger surfaces, such as the manifold,
to clean channels and recesses.
19-6
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
MELT-CUBE SYSTEMS
Hot Runner User Manual