Mold-Masters Hot Runner - 1.8 Units of Measure and Conversion Factors

1.8 Units of Measure and Conversion Factors
NOTE
The dimensions given in this manual are from original manufacturing
drawings.
All values in this manual are in S.I. units or subdivisions of these units.
Imperial units are given in parenthesis immediately after the S.I. units.
Table 1-2 Units of Measure and Conversion Factors
Unit Abbreviation Conversion value
bar Bar 14.5 psi
in. Inch 25.4 mm
kg Kilogram 2.205 lb
kPa Kilopascal 0.145 psi
lb Pound 0.4536 kg
lbf Pound force 4.448 N
lbf.in. Pound force inch 0.113 Nm
min Minute
mm Millimeter 0.03937 in.
mΩ Milliohm
N Newton 0.2248 lbf
Nm Newton meter 8.851 lbf.in.
psi Pound per square inch 0.069 bar
psi Pound per square inch 6.895 kPa
rpm Revolutions per minute
s Second
°
Degree
°
C
Degree Celsius
0.556 (
°
F -32)
°
F
Degree Fahrenheit
1.8
°
C +32
1-3INTRODUCTION
Hot Runner User Manual
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.