Mold-Masters Hot Runner - Pre-Assembly of Accu-Line with Valve Insert

17.4 Pre-Assembly of Accu-Line™ with Valve
Insert
NOTE
The Accu-Line™ with valve insert is used in Deci and Hecto systems only.
For Centi applications, see “17.1 Accu-Line™ with Valve Bushing” on page
17-1.
1. Make sure that the length of your valve pin is the same as that of the
General Assembly drawing.
2. Make sure that your components match those of the parts list:
A
F
S
T
N
X
G
O
L
P
M
H
I
Q
J
K
R
B C D E
U
Y
AA
AB
V
W
Z
17-10
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
ACCU-LINE™
Hot Runner User Manual