Section 16 - TIT Edge Gated
System
WARNING
Ensure that you have fully read “Section 3 - Safety” before assembling,
installing or removing any non-standard components.
The following section contains procedures on non-standard components.
16.1 TIT Edge Gated System
Edge gated systems are supplied with gate seals that are oversize. They
must be ground prior to installing the nozzle into the nozzle well bore. (Minus
heat expansion).
NOTE
Exception - gate seals supplied without the gate. The gate must be placed
into gate seal after the seal is ground to the nal dimension. Refer to gate
detail on the General Assembly drawing.
Heat expansion of the nozzle must also be considered.
Figure 16-1 TIT Edge gated system
Figure 16-2 TIT Edge gate seal
16-1TIT EDGE GATED SYSTEM
Hot Runner User Manual
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
To Next Page
