4.3 Unpacking
WARNING
Make sure the lifting eyebolt, lifting chain and crane are rated to adequately
support the weight. Failure to do so can cause a serious injury.
Make sure the machine has been locked out and tagged out in accordance
to the machines documented procedures. Failure to do so may lead to
serious injury or death.
1. Carefully remove all components from the shipping box and check that all
components listed on the packing slip were supplied.
2. Check that all mold base dimensions are correct and correspond to Mold-
Masters General Assembly drawings.
4.4 Cleaning
1. All nozzles, manifolds and Hot Runner components must be free of the
rust inhibitor applied at the factory.
2. Disassemble the system.
3. Wipe down the nozzle body.
4. Remove the part and wipe clean.
5. If necessary, use a cotton swab to clean narrow interior surfaces or screw
threads. For large surfaces such as mold plates, use thinner in spray form
to clean channels and recesses.
4-3PREPARATION
Hot Runner User Manual
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
To Next Page
Loading...
