Mold-Masters Hot Runner - 19.4 Melt-CUBE Design B

19.4 Melt-CUBE Design B
CAUTION
All cleaning, assembly and installation procedures for the Melt-CUBE must
be done at room temperature, between 10°C and 40°C (50°F and 104°F).
CAUTION
19.4.1 Melt-CUBE Design B: Components
11
10
9
8
7
5a 5b
6
1
2
3
4
1. M8 bolt (melt block bolting)
2. M6 bolt (manifold bolting)
3. Titanium washer
4. Rectangular washer
5. Gate seal
5a. Transfer seal
5b. Torpedo
** this part is only to be used for 40mm and 50mm pitch 8 cavity Melt-CUBEs
Figure 19-6 Melt-CUBE Design B components
5
6. Melt Block assembly
7. Melt-CUBE assembly
8. Retainer clamp (if required) **
9. Support bushing
10 Locating cam
11. Hollow dowel pin
19-19MELT-CUBE SYSTEMS
Hot Runner User Manual
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.