Mold-Masters Hot Runner - Melt-CUBE Design B: Disassembly of Transfer Seal; Torpedo and Melt Block

Melt-CUBE Design B: Disassembly of Transfer Seal /
Torpedo and Melt Block - continued
With needlenose pliers
With spark plug pliers
Figure 19-30 Remove the gate seal
6. Gently clean the sealing interfaces of the melt block and the gate with an
abrasive cloth. See Figure 19-31.
Figure 19-31 Clean the melt block and gate seal
7. Clean the manifold interfaces on Melt-CUBE using a ne polishing stone.
See “Figure 19-10 Clean manifold interfaces” on page 19-21.
8. Inspect the sealing surfaces for any damage.
IMPORTANT
If the sealing surfaces on either the gate seal or the melt block show
signicant damage, the part should be replaced to avoid leakage.
9. Reassemble the Melt-CUBE. See “19.4.8 Melt-CUBE Design B:
Assemble the Melt-CUBE” on page 19-25.
19-31MELT-CUBE SYSTEMS
Hot Runner User Manual
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.