Mold-Masters Hot Runner - One-Piece Melt-Link

18.7.2 One-piece Melt-Link
1. Apply anti-seize compound to the threads of the 1-piece Melt-Link, using
Mold-Masters supplied compound.
2. Thread the Melt-Link into the nozzle.
3. Torque the Melt-Link COLD to the value specied in the General
Assembly drawing.
4. Assemble Melt-Disks onto the nozzles according to mold design.
5. Ensure the sharp edge of the Melt-Link does not get damaged.
Do not damage
sharp edge
18-10
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
MELT-DISK SYSTEM
Hot Runner User Manual