Mold-Masters Hot Runner - Nozzle Insertion-Thinpak Centi and Deci

5.10.3 Nozzle Insertion—ThinPAK Centi and Deci
Refer to the following gure to identify the components.
4
3
2
1
1. Hardened washer
2. Disc spring
3. Anti-rotation dowel
4. Nozzle
Figure 5-7 ThinPAK and MasterSHIELD nozzle and components
1. Clean the nozzle well seating bore.
2. Install the hardened washer.
3. Apply high temperature grease to the spring and install the disc spring
with the correct orientation.
THIS SIDE
UP
4. Install the nozzle.
5-14
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
ASSEMBLY
Hot Runner User Manual