CAUTION
The mold temperature must be more than 80°C to user chillers.
CAUTION
3. Insert the jiy plugs (for the cooling connection) into the supply ports of
the cylinder.
NOTE
The following step is only required when there are cooling lines within the
plates. In this case, use the bottom ports for the cooling connections as
shown in the General Assembly drawing.
4. Insert the plugs into the supply ports of the cylinder, and seal the lines.
In / out cooling lines within the plate
5. Apply grease to the guide ring, piston seal, and rod seal assembly
grooves in the outer surface of the piston.
17-12
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
ACCU-LINE™
Hot Runner User Manual
To Next Page
