Mold-Masters Hot Runner - Page 7

12.8.1 SE40-20 and SE40-20C Models:.........................................................12-11
12.8.2 SE20-15 Model ....................................................................................12-12
Section 13 - E-Drive ....................................................... 13-1
13.1 Typical E-Drive System...................................................................................13-1
13.1.1 E-Drive Components .............................................................................13-3
13.1.2 E-Drive Safety ........................................................................................13-4
13.2 Assembly ........................................................................................................13-5
13.3 Assembly Detail ..............................................................................................13-6
13.3.1 Hot Runner Assembly ............................................................................13-6
13.3.2 Interface Plate Assembly .......................................................................13-6
13.3.3 Synchro-Plate Assembly ........................................................................13-7
13.3.4 Ball-Screw Preparation ..........................................................................13-8
13.3.5 Ball-Screw Lubrication ...........................................................................13-8
13.3.6 Ball-Screw Assembly .............................................................................13-9
13.3.7 Ball-Screw Maintenance ......................................................................13-10
13.3.8 Top Plate Assembly .............................................................................13-10
13.3.9 Attach the Synchro-Plate to Top Plate Assembly ................................. 13-10
13.3.10 Tension Belt Assembly .......................................................................13-10
13.3.11 Inspect Parallelism of the Synchro-Plate ...........................................13-12
13.3.12 Assemble the Insulation Plate and Locating Ring..............................13-12
13.3.13 Perform E-Drive Controller Checks ...................................................13-13
13.3.14 Install the Hot Half into the Mold ........................................................13-13
13.4 First Time Installation or Replacement of the Belt ........................................13-13
13.5 Check for Misalignment ................................................................................13-15
Section 14 - Mag-Pin Option ......................................... 14-1
14.1 Mag-Pin Assembly (3D View) .........................................................................14-2
14.2 Mag-Pin Safety ...............................................................................................14-2
14.3 Mag-Pin Operation .........................................................................................14-3
14.4 Handling Magnets ........................................................................................... 14-5
14.5 Assembly Summary ........................................................................................14-6
14.6 Assembly Details ............................................................................................14-6
14.6.1 Place the Magnet on Top of Magnet Retainer .......................................14-7
14.6.2 Polarity Check ........................................................................................14-7
14.6.3 Clean the Magnet Holder .......................................................................14-7
14.6.4 Assemble the Magnetic Retainer to Magnet Holder ..............................14-8
14.6.5 Place the Magnet Holder and Magnet into the Housing ........................14-8
14.6.6 Assemble the Nut and Lock Magnet Holder ..........................................14-9
14.6.7 Assemble the Valve Pin into the Valve Pin Holder .................................14-9
14.6.8 O-Ring Installation into Valve Pin Holder .............................................14-10
v
Hot Runner User Manual
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.