(00292)H 4 - 17
Trigger Selection Select connector for external trigger signal input.
TRIG1 Input Polarity Select TRIG1 input polarity.
TRIG2 Input Polarity Select TRIG2 input polarity.
TRIG1 Filter External trigger signal noise filter.
TRIG2 Filter External trigger signal noise filter.
Trigger Delay Trigger signal delay setting of ULTRA Cam.
Trigger Edge Detection
Select trigger detection. OFF: Level, ON: Edge.
Trigger Output Mode Select trigger output mode and TRIG OUT output signal.
STATUS TRIG OUT signal indicates that trigger was detected.
TRIGOUT TRIG OUT signal is used as a recording trigger to cameras and
other instruments. Refer to page 8-25 for details.
Trigger Output Polarity
Select TRIG OUT output polarity.
ARM Status Output Polarity
Select ARM status signal polarity output by camera.
FAULT Status Output Polarity
Select FAULT status signal polarity output by camera.
ARM Command Input Polarity
Select ARM command signal polarity input to camera.
EPO(Exposure Pulse Output)
Select EPO signal polarity output by camera.
The following items are HX,GX video display items. Refer to page 6-14 for details
Warning Select whether or not to display HX, GX camera warnings.
On screen display
Select items for the on screen display.
Frame Counter Display
Set the format for the frame counter displayed in the video.
Image Center Mark Select the mark for the center of the image displayed in the video.
DATETIME Display during Recording
Select the DATETIME displayed in the video. Trigger/Current
OSD Display Mode Select the mode to display the on screen display.
Standards for Frame Relative Time
Select the standard time for the relative time during a frame time exposure.
The following items are HX camera items.
Auto Black Balance Settings
Select whether or not to perform black balance automatically.
(refer to page 4-38)
HX Monitor Output
Select whether or not to output videos to the monitor connected to the camera
The following items are Q camera items.
Sync output signal
Select signal output from “SYNC OUT” cable.
(refer to page 3-9)
G trigger
Function to detect trigger by G sensor, which is built in camera and
sensed by shock. By setting as “ON”, trigger signal is generated by
shock given to camera body, in addition to standard trigger signal
generated by user’s facility
G trigger level
Specify impact level to generate trigger signal.
The unit is [G] (acceleration).
To Next Page
Loading...