NEC DSX Software Manual

Call Waiting / Camp-On
DSX Software Manual Features ◆ 59
Features
Programming
1. In 2102-01: Class of Service (page 724), check the sending extension’s Class of Service level.
2. If yes, in 1402-03: Camp-On to Busy Extension (page 633), enter Yes for the initiating extension.
- Check step 2 below to be sure Camp-On is not blocked by the receiving extension.
- This option does not restrict Callback.
3. If no, in 1402-03: Camp-On to Busy Extension (page 633) enter No.
1. In 2102-01: Class of Service (page 724), check the receiving extension’s Class of Service level.
2. If yes:
- In 1512-02: Call Waiting Tones (page 657), be sure Camp-On is enabled system-wide (Yes).
- In 2116-01: Off Hook Signaling for Incoming Intercom Calls (page 749), enter 1 to enable receiv-
ing Camp-On tones at an extension.
- In 1401-03: Privacy (page 628), enter No to be sure that Privacy does not block incoming
Camp-On signals.
3. If no, do one of the following:
- To disable Camp-On system-wide, in 1512-02: Call Waiting Tones (page 657) enter No.
- To disable Camp-On for a specific extension, in 2116-01: Off Hook Signaling for Incoming Inter-
com Calls (page 749) enter 0.
- To have Privacy block incoming Camp-On tones, in 1401-03: Privacy (page 628) enter No.
1. Should an extension be able to send Camp-On tones to a busy co-worker?
2. Should an extension be able to receive Camp-On tones when a co-worker camps-on?

NEC DSX Specifications