NEC ELECTRA ELITE IPK II - Rack Mounting the Basic KSU

___________________________________________________________________________________
5 - 16 Installing KSUs
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
3.6 Rack Mounting the Basic KSU
The RAK-U( ) Unit is a 19 inch unit used to simplify installation by rack
mounting the Electra Elite IPK II system.
1. Mount the RAK-U( ) Unit to the equipment rack using the six provided
screws. Refer to Figure 5-12 RAK-U( ) Unit and KSU. Use three screws
on the right side (at 1, 2, and 3) and three screws on the left side.
2. Mount the Wall Mount Bracket onto the RAK-U( ) Unit using the four
provided screws. Install two screws in the upper holes (at A) and two
screws in the lower holes (at A
1
).
3. After the bracket is mounted to the RAK-U( ) Unit, hang the KSU on the
two hooks protruding from the Wall Mount Bracket, as shown in Figure
5-13 Hanging the KSU on the Bracket.
Figure 5-12 RAK-U( ) Unit and KSU
RAK-U10 Unit
2
3
A
1
A
1