NEC ELECTRA ELITE IPK II - Ctp( )-U10 Etu; Checklist of Components; Description

Electra Elite IPK II Document Revision 3
System Hardware Manual 6 - 103
___________________________________________________________________________________
___________________________________________________________________________________
7.3 CTP( )-U10 ETU
7.3.1 Description
This ETU is a multiplatform system that supports a maximum of 16
ports.
This ETU is a PC platform installed in the Electra Elite IPK II that
contains data storage for voice recording and application software.
A digital signal processor/voice processing section handles the
following functions:
J DTMF detection
J DTMF generation
J General tone detection
J FAX CNG tone detection
J PCM compression for audio recording/playback
J Automatic gain control (AGC)
J Two USB 1.0 ports for USB Keyboard and Mouse support
J One 15-pin VGA connector for VGA monitor support
7.3.2 Checklist of Components
This section describes the steps for assembling a CTP( )-U10 ETU.
Confirm that you have all of the components for the installation. If
you did not receive all the components, call your sales
representative.
J CTP( )-U10 ETU
J Memory SO-DIMM 256M
J DSPII-U10 Unit, two for 12- or 16-port installations
J Drive