NEC ELECTRA ELITE IPK II - Fax CO Branch Connection

Electra Elite IPK II Document Revision 3
System Hardware Manual 5 - 9
___________________________________________________________________________________
___________________________________________________________________________________
2.6 Fax CO Branch Connection
This connection is made via the fourth port on any four port analog ETU (COI,
COIB, or COID). Refer to Figure 5-3 Fax CO Branch Connection. The
facsimile machine is connected to the eighth port for the specified slot where
the Analog CO ETU is installed.
SECTION 3INSTALLING BASIC AND EXPANSION KSUS
The compact design of the Electra Elite IPK II KSU provides easy installation. The
KSUs can be floor mounted or rack mounted. Only the Basic KSU can be floor
mounted. The floor mounting option is for demonstration purposes only. The
information in this section provides detailed instructions for installing the KSU.
J Before beginning installation, ensure that the Power Supply Unit (PSU) is OFF
and that the power cord is disconnected from the AC outlet.
J Do not touch the soldered surfaces of the ETUs.
Figure 5-3 Fax CO Branch Connection
RJ-11
T1
R1
T2
R2
T3
R3
T4
R4
T8
R8
FAX
T
R
T
R
T
R
T
R
Demark
CO
Before installing the system; observe the following precautions.