NEC ELECTRA ELITE IPK II - Section 11 Adjusting the Height on a Multiline Terminal

___________________________________________________________________________________
8 - 26 Installing Electra Elite IPK Multiline Terminals
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
SECTION 11 ADJUSTING THE HEIGHT ON A MULTILINE TERMINAL
The base plate on the Multiline Terminal is hinged to allow the height of the terminal
to be raised or lowered.
1. Grasp in the middle of the hollow spaces at the top and pull up until the retaining
tabs click to raise the base plate. Refer to Figure 8-31 Raising the Height on the
DTH/DTR/ITH Multiline Terminal.
2. After the height is adjusted, pull the line cord though the groove in the bottom of
the Multiline Terminal and adjust it.
3. Push on the adjustment tabs on the side of the stand and push down to lower
the base plate. Refer to Figure 8-32 Lowering the Base Plate on the Multiline
Term in al.
Figure 8-31 Raising the Height on the DTH/DTR/ITH Multiline Terminal
Figure 8-32 Lowering the Base Plate on the Multiline Terminal