NEC ELECTRA ELITE IPK II - Series I or D; System Requirements and Specifications; Cabling Requirements and Specifications

___________________________________________________________________________________
3 - 22 System Specifications
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
SECTION 5SYSTEM REQUIREMENTS AND SPECIFICATIONS
5.1 Cabling Requirements and Specifications
The KSU is connected with each Multiline Terminal and Single Line
Telephone by a separate twisted 1-pair cable or 2-pair cable (only for Multiline
Terminals). Refer to Figure 3-2 Connecting the ESI Using Twisted 2-Pair
Cable.
Refer to Table 3-6 D
term
Series i or D
term
IP Terminal Loop Resistance and
Cable Length.
Refer to Table 3-7 Electra Elite/D
term
Series E Multiline Terminal Loop
Resistance and Cable Length.
Refer to Table 3-8 Cable Connection Between the Analog Port and the Single
Line Equipment.
Refer to Table 3-9 Cabling Requirements.
Table 3-6 D
term
Series i or D
term
IP Terminal Loop Resistance and Cable Length
Terminal or
Adapter
Maximum
Loop
Resistance
(without
AC
Adapter)
(Ohms)
By
Twisted
1-Pair
Cable
(without
AC
Adapter)
24 AWG
By
Twisted
2-Pair
Cable
(without
AC
Adapter)
24 AWG
Maximum
Loop
Resistance
(with AC
Adapter)
(Ohms)
By
Twisted
1-Pair
Cable
(with AC
Adapter)
24 AWG
By
Twisted
2-Pair
Cable
(with AC
Adapter)
24 AWG
DTH-8-1 TEL
DTR-8-1 TEL
37 700 1400 107 2000 2000
DTH-8D-1 TEL
DTR-8D-1 TEL
ITH-8D-2/3 TEL
37 700 1400 107 2000 2000
DTH-16-1 TEL
DTR-16-1 TEL
35 660 1320 107 2000 2000
DTH-16D-1 TEL
DTR-16D-1 TEL
ITH-16D-2/3 TEL
35 660 1320 107 2000 2000
DTH-32D-1 TEL
DTR-32D-1 TEL
26 500 1000 107 2000 2000
DTH-16LD-1 TEL
37 700 1400 107 2000 2000
DCR-60-1
Console
,
— — — 107 2000 2000
, An AC Adapter is required.