NEC ELECTRA ELITE IPK II - Connectors; ETU Compatibility; LED Indications

___________________________________________________________________________________
6 - 68 Installing ETUs (Circuit Cards)
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
6.3.4 ETU Compatibility
ESIB(8)-U10/U20 ETUs and ESIE(8)-U10/U20 ETUs are compatible
as indicated by the table below.
6.3.5 LED Indications
LIVE LED indications are listed below:
J Blinking Red Normal Operation.
J Steady Red Operation Stopped (Power ON).
J Off No Power.
LED1 indications are listed below:
J Steady Red Some Port(s) are busy.
J Off All ports are idle.
6.3.6 Connectors
The following connectors are included:
J CN1 Connects to the backplane.
J EXCN1 Connects to EXCN1 on the ESIE(8)-U20 ETU.
J EXCN2 Connects to EXCN2 on the ESIE(8)-U20 ETU.
Electra Elite IPK Electra Elite IPK II
ESIE(8)
U10
ESIE(8)
U20
ESIE(8)
U10
ESIE(8)
U20
ESIB(8)-10 X X X1 X1
ESIB(8)-20 in U10 Mode X X X1 X1
ESIB(8)-20 in U20 Mode N/A N/A N/A X2
X Supported
N/A Not supported
X1 Does not support SLTII(1)-U( ) ADP, AP(A/R)-R Port Adapters,
PGD(2)-U10 ADP or Multiline Terminals with CT(U/A)-R units installed.
X2 Supports SLTII(1)-U( ) ADP, AP(A/R)-R Port Adapters, PGD(2)-U10 ADP
or Multiline Terminals with CT(U/A)-R units installed.