EasyManua.ls Logo

NEC ELECTRA ELITE IPK II - Connecting the Telephone Cords; Installation Precautions

NEC ELECTRA ELITE IPK II
642 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
___________________________________________________________________________________
13 - 18 Installing Cordless and Wireless Telephones
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
8.3 Installation Precautions
To ensure optimum performance follow these guidelines:
J
Each base unit must be placed at least 15 feet apart.
J
The base antenna should be raised to the vertical position.
J
Always place the base unit on top of a desk or on higher shelves. Avoid
locations surrounded by metal surfaces.
J
Place the base away from any electrical component such as a PC,
monitor, or other telephone.
8.4 Connecting the Telephone Cords
When connecting the telephone cords, observe the following precautions:
J
Never install telephone wiring during a lightning storm.
J
Never touch bare telephone wires or terminals unless the telephone line
is disconnected at the network interface.
J
Use caution when installing or modifying telephone lines.
To connect the telephone cords:
1. Connect the cord from the telephone jack to the Base Unit LINE IN jack.
Figure 13-11 Connecting Base Unit to the Telephone Jack
Line in From
Telephone
Jack

Table of Contents

Other manuals for NEC ELECTRA ELITE IPK II

Related product manuals