NEC ELECTRA ELITE IPK II - General Information; Preparing Multiline Terminal for Adapter Installation

System Hardware Manual 11 - 1
___________________________________________________________________________________
___________________________________________________________________________________
Installing Electra Elite
Optional Terminal Equipment
Chapter 11
SECTION 1GENERAL INFORMATION
The Electra Elite optional equipment can be purchased separately from the system
and added as the customer business grows. Except as noted, these adapters can be
installed on Electra Elite Multiline Terminals. The adapters can also be used with
D
term
Series E (DTP) Multiline Terminals.
A Multiline Terminal can have up to three adapters installed at the same time. When
attaching an APR-U, CTA-U, CTU(S)-U, or HFU-U Unit an external power supply is
required. Only
one power supply is needed even when more than one adapter is
installed.
When an adapter is installed in a terminal for the first time, the base cover on the
Multiline Terminal may have to be modified. The base cover has two access panels
that are removed before the cover can be closed over the adapters to complete the
installation.
SECTION 2PREPARING MULTILINE TERMINAL FOR ADAPTER INSTALLATION
To prepare the Multiline Terminal for adapter installation:
1. Unplug the telephone cord from the terminal.
2. Turn the terminal upside down. Push the tabs indicated in Figure 11-1 Raising
the Base Plate, and raise the inner area of the base plate.