NEC ELECTRA ELITE IPK II - Adjusting the Volume; Configuring the Headset to Your Telephone

Electra Elite IPK II Document Revision 3
System Hardware Manual 13 - 7
___________________________________________________________________________________
___________________________________________________________________________________
4.4 Configuring the Headset to Your Telephone
When any of the following situations occurs, the Headset must be configured
to be compatible with your telephone:
J Dial tone is not present.
J The caller is not heard.
J The caller does not hear you.
J Hissing or buzzing is heard in the Headset.
To configure the Headset:
1. Lift the telephone handset.
2. Press the Talk Button.
3. Locate the configuration Dial, and rotate it to another of the four
positions until a dial tone is heard.
 Align the number with the seam line on the right side.
4.5 Adjusting the Volume
Listening Volume
1. Adjust listening volume using Listening Volume/Mute control on the
headset speaker end.
 Rock the control up or down for volume changes.
2. When the volume is still too loud or too soft, locate the Listening Volume
Major Switch on back of the Base, and move it to another of the four
positions.
Speaking Volume
1. Adjust speaking volume using the plus or minus button on back of the
Base.
2. When the volume is still too loud or too soft, locate the four-position
switch on the bottom of the Base, and move it to another of the four
positions.