NEC ELECTRA ELITE IPK II - Removing the Base Cover

___________________________________________________________________________________
8 - 38 Installing Electra Elite IPK Multiline Terminals
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
3. Refer to Figure 8-51 Connecting Terminal to the System, place the
plastic panel over the Line Card, and push down the corners until they
click into place.
14.5 Removing the Base Cover
The height of the Multiline Terminal can be lowered by removing the Base
Cover.
1. Turn the Multiline Terminal upside down, refer to Figure 8-52 Pressing
Knob to Release Base Cover, and press on the knob to release the Base
Cover.
Figure 8-51 Connecting Terminal to the System
Figure 8-52 Pressing Knob to Release Base Cover