NEC ELECTRA ELITE IPK II - VMS(2);(4);(8)-U( ) ETU Connectors; VMS-U30 ETU Connectors; VMS-U30 ETU Jumper Settings

___________________________________________________________________________________
6 - 142 Installing ETUs (Circuit Cards)
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
7.6.5 VMS(2)/(4)/(8)-U( ) ETU Connectors
The following connectors are included:
J CN1
Connects to the backplane.
J 9-pin RS-232 (COM2)
Not used (MDM-F-20 Unit)
J RJ-11 modem port (COM2)
Remote connector on serial interface (MDM-F-20 Unit)
J 9-pin RS-23 (COM1)
Local Serial connector on main ETU for direct connection
7.6.6 VMS-U30 ETU Jumper Settings
7.6.7 VMS-U30 ETU Connectors
The following connectors are included:
J J2 Connects to the backplane.
J J6 Used for Compact flash drive on FMS.
J J9 RJ-45 LAN connector for network connection
J J11 COM port for console programming connection
J J12 Port expansion connector for DSP-U30
J7 Used only on VMS
Pin 1 to Pin 2 Compact flash is master drive.
Pin 2 to Pin 3 Hard Drive is master drive (default).